![]() ![]() It can be convenient to have the ability to enable and disable individual maps.There are a few different ways that you can transfer maps from Garmin Basecamp to your GPS. When loaded as individual files, each map may be individually enabled and disabled from the on-device “Setup|Map|Map Information Select Map” menu. As there multiple “.img” files are permitted on the device, it is relatively simple to load more than one map set on the device.This makes it easier to enable and disable the map in the on-device “Setup|Map|Map Information Select Map” menu. Though there is no particular requirement to do so, when maps are distributed as multiple “.img” files, use the mkgmap command “mkgmap –gmapsupp mapA.img mapB.img mapC.img ” to combine them into a single file.If the “Garmin” directory does not exist on the SD-card, one must be created. As with older devices, they must reside in a directory called “Garmin” on the SD-card (so the full path is “Garmin/*.img”). These devices can load multiple “*.img” files.img files you will need to merge them together – this can be done with the mkgmap command “mkgmap –gmapsupp mapA.img mapB.img mapC.img ”. There can only be one “gmapsupp.img” file, so if the map is distributed as several.If the “Garmin” directory does not exist on the SD-card, you will have to create it. ![]() This file must be in a directory called “Garmin” on the SD-card (so the full path is “Garmin/gmapsupp.img”).
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |